These cute 'Print and Cut' nautical mini treat bags make adorable baby shower favors! Plus using your Silhouette Cameo it only take a few minutes to cut and assemble these bags. Fill them with your favorite small candies. Please read below for the assembly instructions. Each of these 'Print and Cut' design files can be purchased separately from the Silhouette America Design Store.
DIMENSIONS
Each bag is approximately 4.18" tall, 1.5" deep and 3" wide.
SUPPLIES NEEDED
- Colour printer & ink
- White 8.5" by 11" Cardstock (65 lb)
- Glue or tape
- Thin ribbon or Baker's Twine
- Silhouette Cameo & Mat
Step1: Align the design in your Silhouette Studio software so that it fits inside your registration guides. Next print the design with the registration marks onto white card stock. Select 'card-stock' as the material in your cut settings, then load your cutting mat with your design into your Silhouette Cameo. Once cut, crease the perforated edges along the sides of the bag.
Step2: Apply glue to tab 1 and fold over the opposite edge of the bag to meet this tab. Hold until dry.
Step3: fold over tab 4 and apply glue to the underside of tabs 2 and 3. Once dry apply glue to the top of tabs 2, 3, and 4. Fold over the last bottom tab of the bag.
Step 4: Insert your goodies! And thread ribbon or twine through all the holes on the base of the bag and the top flap. Voila! Your treat bag is ready to gift!
~Thank-you for checking out this design and others! Please note that all of printable designs sold through our Little Luxuries Loft Etsy Shop are in PDF format only, if you wish to purchase Silhouette Studio or SVG design cut files you can do so through the Silhouette America Design Store :)